RAM Mounts Stem Mount Finger Grip Cell Phone Kit

The RAM-B-176-UN4 consists of a double socket arm, hardware for mounting to your motorcycle stem, and finger grip cell phone holder. Designed into the mount is a 1″ diameter patented rubber ball and socket system with adjustment points at the both ends of the socket arm; this with a twist of the arm knob, allows you can move the mount to your optimum viewing position. The included finger grip cradle is designed to hold a large amount of cell phones and electronic devices. The holder comes with 3 sets of four flexible rubber coated fingers placed along sides to grip your device. The fingers open by squeezing the ends to open the small finger arms. The bottom of the holder includes a back plate that adds support to the device being held by the mount.

The fork stem mount is one of the cleanest ways to mount small electronics on your motorcycle. Simply slide the assembly into the hole of the stem and tighten the machine screw to create a tight fit. This part is designed to fit into the cylindrical bore wall of fork stems and will work with stems that measure from 12 -20mm and 28mm or 0.5” – 1.10” at the following intervals:

MetricStandard12mm 0.5”14mm 0.55”16mm 0.63”18mm 0.71”20mm 0.79”28mm 1.10”

• Cell Phones (check measurements below for dimensions)
• 2-Way Radios
• GPS Devices
• Minimum with Top and Bottom Plates: 5.25″
• Maximum with Top and Bottom Plates: 6.0″
• Top and bottom plates can be removed for larger devices
• 2.5W x 5.0H”
• 3″ Long
• Maximum Depth: 0.75″
• Minimum Width: 1.25″
• Maximum Width: 3.0″
• Maximum Depth: 1.25″
• Minimum Width: 1.5″
• Maximum Width: 3.5″
• Maximum Depth: 1.6″
• Minimum Width: 2.25″
• Maximum Width: 3.5″
• Powder Coated Marine Grade Aluminum
• 1″ Rubber Ball “B” Size

Specifications

Part Numbers Specification