Giant Loop Vinyl Protective Film

Giant Loop Vinyl Protective Film takes the abuse – NOT your painted and plastic surfaces!

Protect bodywork and plastics from scuffing or marks under Giant Loop’s saddlebags and tank bags with Giant Loop Vinyl Protective Film. Even a single ride can buff the shine off your gloss coat. Take a few minutes now to keep your bike looking like new.

INSTALLATION TIPSPLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE YOU BEGIN WORK!

• Installs in minutes
• Heavy-duty 12 mil film (used for race bike graphics)
• 3 sheets
• 12″ x 14″
• Made in USA
• Clean surface thoroughly to remove residue and oils. On new plastics, use brake cleaner or carburetor cleaner to remove plasticizers from surface – alcohol and household cleaners will not work
• Work in warm area with warm vinyl sheets. Use hair dryer to warm sheets if needed
• Use razor blade knife to trim sheet to shape
• In spray bottle add 1 drop liquid dish soap to 16 ounces of warm water
• Spray solution onto bike plastic/bodywork and onto both sides of vinyl sheet
• Place wet vinyl sheet onto plastic/bodywork and float into place
• Gently squeegee water and bubbles out from under vinyl sheet. Start with fingers, then use a folded piece of this header card to finish
• Wait 4-6 hours before riding to allow moisture to evaporate. Gently work out any remaining bubbles

Specifications

Part Numbers Specification